TMW Machine: #138
Manufacturer: Brandt
Model: KDN 340
YMFG: 2006
Voltage: 230V 60Hz 1Ph
Condition: Excellent Condition
Price: SOLD
Location: Northwest
Description:
Brandt KDN-340 Edgebander
Used in a 1-2 man shop and only used 1-2 hours/day. Still connected to power.
Rare factory single phase unit!
-
.4-3mm (1/8") Edge thickness cap.
-
8-45mm panel thickness
-
60mm min. panel width & 140 mm min length
-
Equipped w/infeed heating shoe to pre-heat panel edge
-
hot melt granulate glue system w/fast start-up (10-12 min heat up) w/reversible rotation glue applicator roller & automatic reduction glue temperature adjustment (when idle drops to 150 degrees it takes 2-1/2 min to re-activate)
-
3mm PVC pneumatic guillotine for coil cutoff, automatic feed magazine, coil stock feeds automatically w/guillotine cutoff, all strip stock are fed automatically through strip feed magazine
-
2 roller pressure section (1st driver, 2nd idle) w/electronically controlled & feed speed synchronized drive roll
-
Workstations: vertical travel double motor front & rear end trim with 0-15 degree horz. bevel cap (.25-12,00 RPM motors) top & bottom flush/bevel trimmers (.35HP - 12,000 RPM motors,) bevel 0-15 degrees
-
Top & bottom PVC scraping unit for up to 3 mm radius
-
last station: top & bottom buffing unit (.15 HP - 2,750 RPM motors)
-
Feed speed of 30 FPM - equipped w/ operator control panel at eye level, automatic height adjustment w/top pressure beam for all workstations; electronic line control (no limit switches) digital height indicator on hold down beam, electronic motor brakes on trimmers
-
Approx Dimensions Approx Weight 6' x 2' x 5'H